Cisco cBR Series Hardware Installation Manual page 142

Swap the Supervisor
copy usb0:sup250.txt startup-config
Step 19
Pull out the eUSB.
Step 20 Change the config-reg to 0x2102.
Router(config)# config-register 0x2102
Step 21
Reload the system without saving the configuration on the active SUP.
reload
System configuration has been modified. Save? [yes/no]: no
Step 22 Once the system enter the IOS mode, verify SUP redundancy reach SSO via below show command:
Router# show redundancy
Load for five secs: 41%/2%; one minute: 67%; five minutes: 70%
Time source is NTP, 11:34:45.548 CST Wed Sep 20 2017
Redundant System Information :
------------------------------
Available system uptime = 4 days, 18 hours, 39 minutes
Switchovers system experienced = 2
Standby failures = 0
Last switchover reason = user forced
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 4
Current Software state = ACTIVE
Uptime in current state = 1 day, 23 hours, 59 minutes
Image Version = Cisco IOS Software [Fuji], cBR Software
(X86_64_LINUX_IOSD-UNIVERSALK9-M), Experimental Version
16.7.20171024:133607 [v167_throttle-/nobackup/mcgourtm/v167_throttle_ece2 103]
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Compiled Tue 24-Oct-17 12:43 by mcgourtm
BOOT = bootflash:cbrsup-universalk9.BLD_V167_THROTTLE_LATEST_20171019_050605.SSA.bin,12;
CONFIG_FILE =
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 5
Current Software state = STANDBY HOT
Uptime in current state = 1 day, 23 hours, 49 minutes
Image Version = Cisco IOS Software [Fuji], cBR Software
(X86_64_LINUX_IOSD-UNIVERSALK9-M), Experimental Version
16.7.20171024:133607 [v167_throttle-/nobackup/mcgourtm/v167_throttle_ece2 103]
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Compiled Tue 24-Oct-17 12:43 by mcgourtm
BOOT = bootflash:cbrsup-universalk9.2017-10-24_12.51_mcgourtm.SSA.bin,12
CONFIG_FILE =
Configuration register = 0x2102
Step 23
Verify the state of the 10GE backhaul interface links. If the 10GE backhaul interface links are administratively down,
run the
no shutdown
Step 24
Save the configuration by running the
Step 25 Save & backup current configuration.
copy running-config startup-config
Cisco Converged Broadband Routers Hardware Installation Guide
134
command for the backhaul interfaces.
command.
wr
Installing the Supervisor in the Cisco cBR Chassis