Using Your Machine - Vax Platinum PowerMax ECB1SPV1 Manual

Using your machine

NOTE: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary
to repeat the cleaning process. Make criss-crossing strokes across the original pattern and overlap with each pass.
Filling the water/solution tank and cleaning modes
Press the clean water/
solution tank release
button, pull and lift to
remove the tank.
Tilt and line up the front of
the tank to the washer and
push the tank back until it
clicks into place.
This machine has an auto mix tank so any solution
not used can be poured back into the bottle.
Twist the water/solution
tank cap anti-clockwise
and remove.
Turn the wash/rinse dial
to 'wash'. The SpinScrub
brushes and brushbar
deep clean your carpets
with water and solution
removing dirt and stains.
Pour the required amount
of carpet cleaning solution
into the tank. Tighten the
cap before returning the
tank to the washer.
Plug into the mains,
press the On/Off button
to switch on.
Fill the clean water tank
with warm water (max
40°C). Fill to max fill line
for a Deep Clean, and fill to
the Quick Clean fill line for
a quick surface clean.
Choose the cleaning
mode by turning the dial
on the base.
Quick Clean Mode:
Best for a quick, surface
clean - carpets dry in
less than an hour.
Deep Clean Mode:
Best overall results for
a thorough, deep clean.