Vax Platinum PowerMax ECB1SPV1 Manual page 10

Using your machine
Using the hose and tools
NOTE: The carpet washer should be in the upright position when using the hose and tools; this will de-activate
the SpinScrub brushes and brushbar.
Pour the required amount
of carpet cleaning
solution into the tank.
Push the hose end and
hose solution connector
into the hose and solution
connection port.
Press the trigger on the hose
to release solution/water.
Fill the clean water tank
with warm water
(max 40°C).
Select the SpinScrub or Upholstery tool. Slide the tool
over the tab at end of the hose until it clicks into place.
Squeeze the trigger on the forward stroke and release the trigger
on the backward stroke to pick up water/solution. For a dryer finish,
follow with an additional dry stoke with no trigger pressed.
Turn the wash/rinse dial
to 'wash'.
Pull down the accessory
hose connector cover.
Plug into the mains and
press the On/Off button
to switch on.
Use the carpet washer
or hose to pick up spills
before washing and
cleaning the area.