CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Emptying and cleaning the dirty water tank
IMPORTANT: Empty and rinse out clean and dirty water tanks and leave to air dry before replacing.
Do not leave solution stored in the tanks between uses.
Press the dirty water
tank release latch and
pull the tank to remove.
Clean the filter screen
located at the back of the
dirty water tank.
Pull and lift the dirty water
tank clip to release the lid.
Lift the tank lid to remove.
To re-fit, tilt the dirty water tank
and line the front of the tank up
onto carpet washer. Push back
until it clicks into place.
Using your machine
Empty the dirty water over the sink. Rinse
the dirty water tank and lid under water
(max 40°C) to remove dirt/debris.