Advertisement
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floorhead is not in
contact with the carpet, the float will shut off the suction on the carpet washer. You will be able to hear if this has
happened as the motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full.
If the dirty water tank is not full then turn off your machine at the power switch and wait for the float to settle.
Press the recline pedal
and pull handle backwards.
For tough stains press
the boost trigger together
with the solution trigger
to release more water/
solution mix.
Squeeze the trigger
to release the solution
and water mix.
Turn the wash/rinse dial
to 'rinse'. Only water
is released to remove
solution residue.
Using your machine
For best results apply water/solution on
the forward stroke and release the trigger
on the backward stroke to pick up water/
solution. For a dryer finish, follow with an
additional dry stoke with no trigger pressed.
For best cleaning results use
slow straight parallel strokes.
Intermittent dry forward
strokes will increase water
pick up. The 'rinse' mode
will also work when using
the hose.
Hide quick links:
Advertisement
