Handling Of Received Data When The Printer Goes Into Power Save Mode; Combination Of Bluetooth Model And Applicable Firmware Version - Toshiba B-EP Series Interface Specification

TPCL mode (Issue)
Request for a Bluetooth
connection
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Label size set command to
Issue command
E.g.)
[ESC]XS;I,0001,0002C1011
[LF][NUL]
Status response is
enabled.
A status request
command does not
need to be sent.
Repeat when there is
a next print job.
Request for a disconnection
of the Bluetooth connection
Finish the data storage operation and
return to Main Menu or another screen.
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
3.7.4

HANDLING OF RECEIVED DATA WHEN THE PRINTER GOES INTO POWER SAVE MODE

Data is left in the received buffer until reception is stopped and a timeout occurs (power save
mode) because the received buffer has not been initialized.
3.7.5

COMBINATION OF BLUETOOTH MODEL AND APPLICABLE FIRMWARE VERSION

The following table shows the combination of the Bluetooth model and applicable firmware
version.
Firmware version
V1.3B or before
V2.0 or later
Host Printer
B-EP-GH30/TH30
Applicable
Applicable
3-74
Response to the request for a Bluetooth
connection
Status sent in response to the status
request command.
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 30H30HxxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
The printer is in operation.
Status indicating a normal termination of issue
(After a normal termination of an issue, a status is
automatically sent.)
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 34H30HxxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
Normal termination
Response to the request for the
disconnection of the Bluetooth connection
B-EP-GH32
Not applicable
(BT INIT ERROR occurs.)
Applicable
CHAPTER 3 INTERFACE
B-EP Series
Confirmation
of the printer
status prior
to data
storage
Issue
Waiting
time until
the end of
a print job