Control Unit Installation - Siemens SINAMICS G120P Hardware Installation Manual

Installing/Mounting

3.4 Control Unit installation

3.4 Control Unit installation
The Control Unit is snapped
onto the Power Module as
shown in the figure. To
disconnect the CU push the
release button on top of the
PM.
The process of fitting the
Control Unit to the Power
Module is the same
technique independent from
the type of Control Unit or
Power Module.
22
Fitting the Control Unit to the Power Module
Power Module PM230, IP20 / Push through
Hardware Installation Manual, 03/2012, A5E03448282B AA