Siemens SINAMICS G120P Hardware Installation Manual page 11

Use of mobile radio devices (e.g. telephones, walkie-talkies) in the immediate vicinity of the
devices (< 1.8 m) can interfere with the functioning of the equipment.
Filtered drives can only be used on power systems with grounded neutral point.
During operation and for a short time after switching-off the converter, the surfaces of the
converter can reach a high temperature. Avoid coming into direct contact with the converter
surface.
This equipment is suitable for use in a power system up to 65,000 symmetrical amperes
(rms), for the maximum rated voltage + 10 % when protected by an appropriate standard
fuse (refer to the catalogue for the type of fuse).
Repair
Repairs on equipment may only be carried out by Siemens Service, by repair centers
authorized by Siemens or by authorized personnel who are thoroughly acquainted with all
the warnings and operating procedures contained in this manual.
Any defective parts or components must be replaced using parts contained in the relevant
spare parts list.
Dismantling and disposal
CAUTION
The packaging of the inverter is re-usable. Retain the packaging for future use.
Easy-to-release screw and snap connectors allow you to break the unit down into its
component parts. You can recycle these component parts, dispose of them in accordance
with local requirements or return them to the manufacturer.
Residual risks
The control and drive components of a power drive system (PDS) are approved for industrial
and commercial use in industrial line supplies. Their use in public line supplies requires a
different configuration and/or additional measures.
Power Module PM230, IP20 / Push through
Hardware Installation Manual, 03/2012, A5E03448282B AA
WARNING
WARNING
WARNING
CAUTION
WARNING
Safety notes
11