Table of Contents
Advertisement
Bottom Glass Retainer Clip Instructions
r+%.
(2) Glass Retainer Clips
supplied with the door kit
Follow the instructions in the door kit except for the
bottom glass retainers. Install the special glass retainer
( 4 ) 10-24
x 3/8"
button head allen
clips to the bottom of the door.
screws supplied in the door kit
There is a left and right retainer clip with a radius to match
the door bottom. The fiber glass rope on the clip must be
facing the stove body when installed, NOT FACING
Gasket goes
THE GLASS
! !
toward the stove
(2) ghss retainer clips
,
-
These clips are designed to direct the air wash a i r more
( I )
right hand
evenly.
Gasket goes
toward the stove
Assembling the door
Refening to the diagram, note how the various
components of the door system fit together. Lay the
load door face down on a soft surface.
Clean the glass and gold door using a nonabrasive
9
cleaner. Install the glass gasket around the outer edge of
the front face of the door glass carefully to insure proper
6 '
QI
sealing. Set the glass pane gently onto the door. Install
the hold-down clips and tighten with bolts as shown.
PA W
Install door on stove with hinge pins.
Q
BOLT
Install door handle as shown on the diagram.
@
NOTE: With the flat surface of the paw bolt to the in-
side of the door.
4 GLASS
Turn the paw bolt "in" for approx. (17) turns.
RETAINER CLI
9-
4 GLASS RETAINER
Turn the brass elbow onto the paw bolt approx.
BOLTS
(5) turns.
Align the set screw with the flat spot on the paw
and tighten.
After attaching the door handle, close and latch
the door by turning the handle to the six o'clock posi-
tion. Does the door rope compress? If not, loosen the
set screw, turn the paw bolt one more turn into the door.
Repeat as required to achieve a tight door fit.
NOTE: Remember to thoroughly clean the glass
and the gold door & m e before lighting the stove for the
h t time.
Fig.
2
5
P61A-2 Pellet Stove
Advertisement
Table of Contents
