Table of Contents
Advertisement
Unpacking
The P61 is bolted to the skid to prevent movement
To fiee the stove fiom the skid you must remove
the hold-down bolts in the rear of the pedestal base.
Installing rear cover panels
The rear cover panels are removed h m the stove
to make it easier to get at the hold-down bolts.
The rear cover panels are packed inside the hop-
per and should be installed on the stove as shown. It is
recommended that the rear covers are installed after
the unit is in place and the vent pipe is installed.
Install the firebrick vertically on the angle above
Install the cast iron flame guide on top of the burnpot
and make sure it is fully seated against the auger open-
ing. The bottom of the flame guide is marked 38+.
Panels
DO NOT INSTALL A FLUE DAMPER IN THE
EXHAUST VENTING SYSTEM OF THIS
UNIT.
DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVING ANOTHER
APPLIANCE.
INSTALL VENT AT CLEARANCES
SPECIFIED BY THE MANUFACTURER
Mobile home installation should be done in
accordance with the Manufactured Home and
Safety Standard (HUD), CFR 3280, Part 24.
DO NOT INSTALL IN SLEEPING ROOM
CAUTION
THE S T R U C T L W INTEGRITY OF THE
MOBILE HOME FLOOR, WALL, AND
CEILINGJROOF MUST BE MAINTAINED.
CAUTION
KEEP COMBUSTIBLE MATERIALS
(SUCH AS GRASS, LEAVES, ETC.) AT LEAST 3
FEET AWAY FROM THE FLUE OUTLET ON
THE OUTSIDE OF THE BUILDING.
P61A-2
Pellet Stove
4
Advertisement
Table of Contents
