Table of Contents
Advertisement
I
\
shut down when removing ash pan.
Combustion
Blower Cover
1. Pull on latch handle and remove ash pan as
Blower Cover
Latch
shown at left. Use ash pan handle to carry and
dispose of ashes.
Fig 26
2. Slide the ash pan back into the stove and latch
by pushing in on latch handle.
Cleaning:
The stove will need to be cleaned for approxi-
mately every 2 to
5
tons of pellets burned. The amount
of pellets burned before cleaning will vary depending
Heat Exchanger Fins
on the brand of pellets.
I
/
1. Shut down stove and disconnect power cord to
insure that all motors are stopped.
2. Remove ash pan as described earlier.
3. Remove combustion blower cover by turning the
blower cover latch vertical as shown in Fig.26
and sliding the cover out of the slot on the
1eft.This will expose the combustion blower
wheel and flue outlet, Fig.27.
4. Clean the blower wheel with a brush and a
vacuum cleaner.
5.
Use a brush to clean the flue, being careful not to
damage the ESP probe. The flue goes straight
through into the vent pipe (Fig.27) therefore, the
Blower Cover
vent pipe can also be cleaned to some extent
through the flue outlet.
-
A
Fig 27
6. Reinstall blower cover and relatch.
P61A-2 Pellet Stove 20
Advertisement
Table of Contents
