Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Harman Stove Company RS
Summary of Contents for Harman Stove Company RS
- Page 1 INVINCIBLE "RS" OWNERS MANUAL...
- Page 2 Contents Packing List Installation & Assembly Venting Operation ESP Control Maintenance Wiring Diagram Feeder Parts Trouble Shooting Specifications Warnings Manufactured by Harman Stove Company 352 Mountain House Road Halifax Pa. 17032 (717) 362-9080...
-
Page 3: Packing List
Packing List Inside Stove: Hardware Pack (2) Electrical Terminals (1) 10-32 x 1/2" Bolt (1) 1/4 x 20 x 2 1/2" Bolt (1) Wooden Handle (1) Brass Knob (1) Owners Manual (1) Warranty Activation Coupon (1) Room Sensing Probe (1) Ash Pan (2) Firebricks (1) Scraper (1) Flame Guide... - Page 4 Unlike a wall ther- mostat the RS probe can be placed anywhere and go unnoticed. We recommend the room sensor be in- stalled even if only cut short and connected to room sensor remote ports.
- Page 5 For this reason and the fact that the Invincible RS operates with a positive vent pressure we specify that the joints also be sealed with clear silicone.
- Page 6 #1 Preferred method This method provides excellent venting for nor- mal operation and allows the stove to be installed closest to the wall. Two inches from the wall is safe, however, four inches allows better access to remove the rear panel. The vertical portion of the vent should be three to five feet high.
- Page 7 #4 Installing into an existing chimney ( US only ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure. If the chimney condition is questionable you may want to install a liner as in method #7.
- Page 8 #6 Installing into an existing fireplace chimney ( US and Canada ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure. In Canada and some places in the US it is re- quired that the vent pipe extend all the way to the top of the chimney.
- Page 9 DO NOT INSTALL A FLUE DAMPER IN THE WARNING EXHAUST VENTING SYSTEM OF THIS DO NOT INSTALL IN SLEEPING ROOM UNIT. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER CAUTION APPLIANCE. THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND INSTALL VENT AT CLEARANCES CEILING/ROOF MUST BE MAINTAINED.
- Page 10 Operation Starting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel. Fill the hopper with pellets, fig. 12. Fill the burn pot with pellets to a level just short Fig.
- Page 11 Starting a fire after proper Scrape floor of burn pot with scraper to remove any carbon build-up before Feed Rate is known. starting a new fire. Clean burn pot with scraper (supplied). Fill the hopper with pellets. Fill the burn pot with pellets to a level just short of overflowing.
- Page 12 When to use "Stove Temp Fig. 13 Mode" In "Stove Temp Mode" the Stove Temp Dial determines the temperature of the stove. Heat output and fuel consumption will remain con- stant. This makes it possible to tell how long a hopper full of pellets will last.
-
Page 13: Esp Control
ESP CONTROL Power Light Indicates power to the control. Feed adjuster Secondary function: Sets the maximum feed Blinks every 15 seconds rate when the feed adjuster is in "Test Mode". This verifies feeder switch Test operation. Should be lit Runs all motors at anytime the unit is pluged full speed for two minutes to check...