Table of Contents
Advertisement
Burn Pot Cleanin? and Maintenance
1. Scrape the top holed surface and sides of the burn
pot.(Fig 34) It is not necessary to completely remove
all material from the burn pot. The excess will be
pushed out during the next use.
2. Loosen the (2) wing thumb screws on the lower
front angle of the bum pot. (Fig. 34)
3. Lift off the clean-out cover (Fig.35) to open the
bottom clean-out chamber. (Fig.36)
DANGER
Disconnect the power to the unit before
removing cover.
4. Clean ash buildup from inside the chamber while
cover is off. Use the scraper to tap on the top front
edge of the bum pot. This will help knock pieces of
ash, loosened by the scraping process, down through
-
- -
the holes. It also helps h o c k scale off of the ignitor
element.
Figure 36
The ignitor is made to be removable for service
by insulated malelfemale wire connectors. These
connections between the hot leads (the wires inside
the bum pot) and the cold leads (the wires from the
control board) are always pulled to the inside rear of
the feeder body. (Not coiled inside the burn pot.)
It is very important that these connections are
to the inside rear of the feeder body. Also, the extra
wire of the ignitor wire service loop must be pulled out
through the rear of the feeder and tied up so that it will
not be damaged by any moving parts.
DANGER
Disconnect the power to the unit before
removing cover.
Use caution when cleaning burn pot clean-out
chamber. Do not damage the high temperature
Burn pot ignitor
/
Ignitor hot lead wires
-(high temperature)
Note: The hot leadlcold lead
connection must always be pulled
to the rear of the feeder body
before operation.
P61A-2 Pellet Stove 22
Advertisement
Table of Contents
