Install The Thermostatted Column Compartment (Tcc) (G1316A) - Agilent Technologies 1100 Series System Manual

6 Connect the power cable to the power socket at the rear of the DAD. Do not connect
7 Install the DAD flow cell (G1314-68714).
8 Route the DAD flow cell outlet capillary (G1315-68708) to an appropriate waste
9 Connect the large-bore corrugated plastic leak drain tubing to the DAD leak

Install the Thermostatted Column Compartment (TCC) (G1316A)

Connect the power cable to power only after you have finished the hardware
WARNING
installation of all modules in the stack.
1 Ensure the line power switch at the front of the Thermostatted Column Compartment
2 Place the TCC on top of the DAD. Make sure that the two modules are interlocked
3 Connect the Can-bus cable (5181-1516) to one of the CAN connectors at the rear of
4 Connect the power cable to the power socket at the rear of the TCC. Do not connect
5 Connect the free end of the Can-bus cable from the DAD to the unused Can-bus
6 Place the analytical column into the TCC. Observe the flow direction indicated on
7 Connect the DAD flow cell inlet capillary (G1315-68703) to the outlet of the
1100 Series Capillary LC System Manual
the power cable to power until you have finished the hardware installation of all
modules in the stack.
container. The DAD flow cell inlet capillary (G1315-68703) will later be connected
to the outlet of the analytical column.
drain fitting. Route the leak drain tubing to an appropriate waste container.
(TCC) is off
correctly.
the TCC.
the power cable to power until you have finished the hardware installation of all
modules in the stack.
connector at the rear of the TCC.
the column. The column can later be secured using column clamp (5001-3702).
NOTE
analytical column.
or broken by module front covers. Avoid excessive bending.
handling capillaries.
7
Installing your Capillary LC System 1
Carefully route all capillaries so that they are not crushed
Chapter 2 for advice on