Information - Miele PLW 6111 Operating Instructions Manual

INSTALLATION
A booster pump is required if the flow pressure is below 100 kPa (14.5 psi). If the pressure is
higher than 800 kPa (116 psi), a pressure reducer must be installed.
If water pressure is not within the specified range, contact Miele Service or an authorized service
technician for advice.
A shutoff valve with a ¾" threaded union must be provided on-site. The valve should be easily
accessible, since the water supply should be shut off whenever the machine is not in use.

Information:


The machine is equipped with a safety system for the protection of drinking water and may
be connected to the water supply without a non-return valve, if national regulations permit.

If no hot water supply is available, the red coded inlet hose for the hot water connection
must also be connected to the cold water supply.

A Y-piece can be used to connect both hoses to the cold water supply.

Miele cannot be held liable for damage or injury caused by noncompliance with the safety
instructions and warnings.

Non-compliance with the above conditions will render the warranty invalid.
REV.0.01_COD.650184_A4
WARNING
Do not overtighten the threaded unions on the hoses.
WARNING
When the machine is not in operation, always close the shutoff valves.
Page 18