Measuring Sockets; S5 Dip Switch; Diag Button - Siemens SINAMICS S120 Equipment Manual

Table 8- 14 LED states on the X150 P1/P2 PROFINET interface
LED Color
Link port -
Green
Activity port -
Yellow
8.3.2.12

Measuring sockets

Table 8- 15 Measuring sockets T0, T1, T2
The measuring sockets are only suitable for multiple-spring wire plugs with a diameter of 2 mm.
Note
Measuring sockets support commissioning and diagnosis. It must not be connected for
normal operation.
8.3.2.13

S5 DIP switch

DIP switch S5 is used to switch the analog input between voltage input and current input. It
is located under the blanking cover (see CU310-2 PN Interface Overview (Page 230).)
Table 8- 16 DIP switch S5 - switchover between voltage/current
8.3.2.14

DIAG button

The DIAG pushbutton is reserved for service functions.
AC Drive
Manual, 06/2019, 6SL3097-5AL00-0BP1
Status Description
OFF Missing or faulty link
Continuous 10 or 100 Mbit link available
light
OFF No activity
Flashing Data is being received or sent at port x
Socket Function
T0 Measuring socket 0
T1 Measuring socket 1
T2 Measuring socket 2
GND Ground
Switch Function
S5.0 Switchover between voltage (U) / current (I)
S5.1 Not assigned
Control Units, Control Unit Adapters and operating components
8.3 Control Unit CU310-2 PN (PROFINET)
Technical data
Voltage: 0 ... V
Resolution: 8 bits
Load current: max. 3 mA
Continued-short-circuit-proof
The reference potential is terminal M
243