Expansion Board Holder - HP ProLiant ML150 Generation 2 Maintenance And Service Manual

Removal and Replacement Procedures

Expansion Board Holder

You may need to remove the expansion board holder when removing other components, such
as the system board.
To remove the expansion board holder:
1. Remove the expansion board(s) on the expansion board holder. Refer to "Expansion
Board" earlier in this chapter.
2. Carefully place the server upside down.
3. Remove the two screws securing the expansion board holder to the chassis (1).
4. Remove the expansion board holder from the chassis (2).
Figure 2-38: Removing the expansion board holder
To replace the expansion board, reverse steps 1 through 4.
2-38
HP CONFIDENTIAL Codename: Stone Soup 2 Part Number: 368148-003 Last Saved On: 6/10/05 4:28 PM
HP ProLiant ML150 Generation 2 Server Maintenance and Service Guide