Table of Contents
Advertisement
Removal and Replacement Procedures
SATA Hot-Plug Hard Drive Blank Carrier
NOTE: The server does not need to be powered off to complete this operation.
To remove the SATA hot-plug hard drive blank carrier:
1. Open the bezel door. Refer to "Bezel Door" earlier in this chapter.
2. Push in the locking latch of the desired hard drive blank carrier (1).
3. With the locking latch still being pressed, hold the handle and slide the blank carrier out
of the drive bay (2).
Figure 2-30: Removing a SATA hot-plug hard drive blank carrier
To replace the SATA hot-plug hard drive blank carrier, reverse steps 1 through 3.
2-30
HP CONFIDENTIAL Codename: Stone Soup 2 Part Number: 368148-003 Last Saved On: 6/10/05 4:28 PM
HP ProLiant ML150 Generation 2 Server Maintenance and Service Guide
Advertisement
Table of Contents
