Replacing The Front Cover - IBM Power System E950 9040-MR9 Installing Instruction

2. Using your hand to support the bottom of the fan, align the fan with the fan slot and slide it into the
system.
3. Rotate the fan handle (A) in the direction shown and then press the fan handle until the latch locks in
place. See Figure 20 on page 21.
Figure 20. Replacing a front fan

Replacing the front cover

Learn how to replace the front cover.
About this task
To install the front cover, complete the following steps:
Procedure
1. Move to the front of the rack.
2. Position the cover on the front of the system unit so that the four pins on the system match the four
holes on the rear of the cover.
3. Press the tabs on the cover to snap the cover into position.
Installing the IBM Power System E950 (9040-MR9) 21