Connecting the power cords to the 9040-MR9 system
Use this procedure to connect the power cords to an IBM Power System E950 (9040-MR9) server.
1. If applicable, open the rack door at the rear of the system unit that you are servicing.
2. Using your labels, reconnect the power cords (A) to the system unit as shown in the following figure.
Fasten the power cords to the system by using the hook-and-loop fasteners (B) as shown in the
following figure.
Figure 239: Connecting the power cords
3. Close the rack door at the rear of the system.
Removing the front cover from a 9040-MR9 system
Use this procedure to remove the front cover from a IBM Power System E950 (9040-MR9) server so that
you can access the components or perform service.
1. If necessary, open the front rack door.
2. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
288 Power Systems: Temple's Zeppelin procedures for install, remove, replace