PREPARATION OF THE SNOW
THROWER FOR MOUNTING TO THE
.TRACTOR
TO UNFOLD SNOW THROWER
(See Fig. 12)
•
Raise the rear of the Snow Thrower and slide the
Lift Handle under the front of the Channel Bracket to
allow the frame to unfold to proper position.
•
Unfold the Lower Mounting Frame to a flat position.
•
Check the Lower V-Belt to make sure it is riding in
the grooves of the pulleys.
•
Align the holes in the Lower mounting Frame with
the holes in the Channel Bracket And secure them
in place with six 5/16 x 1-3/4" Bolts and Lock Nuts.
•
Tighten 5/16 x 1-3/4" Bolts and Lock Nuts running
horizontally first, then 5/16 x 1-3/4" Bolts and Lock
Nuts running vertically.
•
Raise the rear of the Snow Thrower and remove the
Lift Handle.
•
Check to make sure the Belt Gauge Run Indicator
extends through the slot in the side of the Upper
Mounting Frame.
TO SECURE THE MOUNTING 'BRACKETS
•
Assemble one 3/8 xi" Hex Bolt through the Right
Front Mounting Bracket and ~pper Mounting Frame
and secure with 3/8" Lock Nut. (See Fig. 12)
•
Assemble one 3/8" xi" Hex Bolt through the left
Front Mounting Bracket and Upper Mounting Frame
and secure with a 3/'8" Lock Nut.
ASSEMBLE REAR MOUNTING BRACKETS
•
Place Rear Mounting Bracket on the,outside at each
side of the Upper Mounting Frame. Brackets must
be angled up. (See Fig. 12)
•
Align holes and secure Left Rear Mounting Bracket
with two 3/8 x 1" Hex Bolts and two 3/8" Lock Nuts.
•
Align holes and secure Right Rear Mounting Bracket
.~
with one 3/8 x 1" Hex Bolt, one 3/8 x 1-1/4" Hex Bolt
and two 3/8" Lock Nuts.
ADDITIONAL PREPARATION OF THE
SNOW THROWER
(HORIZONTAL CRANK SHAFT TRACTORS)
Remove idler spring from snow thrower. (See Fig.
•
12)
Remove chain and toggle assembly from snow
•
thrower.
Remove upper V-belt from snow thrower.
•
Remove the 3/8 x 3/4" Hex Bolt, 3/8" lock washer,
•
3/8" flat washer and 3/4" flat washers that hold the
idler arm to the top of the double pulley assembly.
(See Fig 13)
Remove the idler arm from the top of the double
•
pulley assembly and replace it with a 3/4" long
spacer.
Reassemble 3/4" flat washers. 3/8" flat washer, 3/8"
•
lock washer and secure with the 3/8 x 3/4" hex bolt.
FIG. 13
5/16 X 1-3/4 BOLT
REAR
MOUNTING
BRACKET
~
o_\
.
~
I
UFT
HANDLE
LOWER MOUNTING:
CHANNEL BRACKET
FRAME
~
3/8 x 1 HEX BOLT
/
5/16 x 1-3/4 BOLT
5/16
NYLOCK NUT
RIGHT FRONT
5/16
NYLOCK NUT
MOUNTING BRACKET
FIG. 12
10