Fortinet FortiGate-7000E Series System Manual page 50

FortiGate-7040E management module
Header
\n--- COMLOG SYSTEM BOOT: YYYY/MM/DD hh:mm:ss ---\n
\n--- COMLOG DISABLED: YYYY/MM/DD hh:mm:ss ---\n
\n--- COMLOG ENABLED: YYYY/MM/DD hh:mm:ss ---\n
\n--- COMLOG TIME: YYYY/MM/DD hh:mm:ss ---\n
The following comlog-related CLI commands are available:
Description
Display comlog information.
Available on the passive
module.
Display a module's comlog.
Available on the passive
module.
Clear a module's comlog. Either
by resetting the a comlog start
location in flash (reset_loc) or
erasing all of the flash storage
(chip_erase). Available on the
passive module.
Disable a module's comlog.
Available on the passive
module.
Enable comlog. Available on
the passive module.
Set comlog baud rate.
<speed> can be 9600, 19200,
38400,57600, 115200, or
expressed as level 1 to 4.
Available on the passive
module.
FortiGate-7040E System Guide
SMC CLI Commands
comlog getinfo
Status Disabled
COM Speed 9600
Storage Size 0x00400000
Log Start 0x00000000
Log End 0x00000C37
Log Size 3127 Bytes
comlog getinfo <slot>
comlog print <slot>
comlog clear [reset_loc]
[chip_erase]
comlog disable
comlog enable
comlog setbaud <speed>
Cause
The module is starting up after being powered on
or reset.
Logging is disabled.
Logging is enabled
This message is written every hour when the
module is powered on and logging is enabled.
IPMI commands
fortinetoem comlog getinfo
fortinetoem comlog print
fortinetoem comlog clear
fortinetoem comlog clear
fortinetoem comlog clear
fortinetoem comlog setbaud
<speed>
50
Fortinet Technologies Inc.