206
4-1. Before driving
Removing hitch cover (if equipped)
Remove the clip.
1
Grasp the lower edge of the hitch
2
cover and raise the cover.
When reattaching the cover, reverse the
steps listed.
When connecting and disconnecting a trailer
■
Stop your vehicle and a trailer in line and perform the following:
Connecting a trailer
●
Put the 4-Wheel AHC in the "LO" (low) mode.
1
Turn off the engine switch or the 4-Wheel AHC.
2
Connect a trailer.
3
Turn on the engine switch or the 4-Wheel AHC.
4
Select the N (normal) mode with the height select switch.
5
When a vehicle loaded with four occupants tows a trailer of about 1800 kg (4000
lb.) with more than about 180 kg (400 lb.) tongue load, the normal mode may not
be selected. However, there is no problem to continue normal driving. Drive with
sufficient care because of large load.
LX570_450d_OM_OM60R63E_(GE)