Table of Contents
Advertisement
MAP Control Center
4.
Caution!
The LED on the motion detectors, which indicates the detection of movement, could be used
!
by potential intruders to identify any unprotected parts of the area.
4
5.8.7
Bell and indicator test
How to open the Service menu
4
P
How to execute a bell and indicator test
4
P
P
Notice!
The bell and indicator test cannot be interrupted.
5.8.8
Changing/viewing output state
How to open the Service menu
4
P
How to view and change outputs
1.
2.
P
5.8.9
Manufacturer authorization
The manufacturer authorization grants the manufacturer user access to the system. In case
the panel is certified according to EN Grade 3, the manufacturer user is defined as a user
uploading new firmware to the panel.
The manufacturer authorization expires automatically after a defined amount of time, which
can be configured by the installer.
4
Bosch Security Systems B.V.
The LED on the motion detector flashes to indicate, that the movement has been
detected.
Disable the motion detector test.
Enable the motion detector test function only for maintenance and testing.
Disable the motion detector test function for daily business to switch off the LED.
To open the Service menu, press
The Service menu with twelve menu options is displayed.
Press Bell and Indicator Test.
A message is displayed, stating that the bell and indicator test is in progress.
The green, yellow and red LEDs of the control center light up for three seconds.
The speaker of the control center emits a short beep.
After three seconds the bell test for acoustic alarms has finished.
After three minutes the indicator test for optical alarms has finished.
To open the Service menu, press
The Service menu with twelve menu options is displayed.
Press Change/View Output State.
A list with all outputs is displayed. You can also search for outputs by name or filter
outputs with the status "On" or "Off".
To change the status of an output, press the button of the output.
The
icon indicates that the output is turned on. The
is turned off.
For more information, contact your installer or system administrator.
and
.
and
.
User manual
Operation | en
icon indicates that the output
2019-11 | 08 | F.01U.168.328
29
Advertisement
Table of Contents
