Chapter 2: Unpack the device
!
CAUTION:
Wear an anti-static wrist ground strap whenever you handle components of a G450 Media
CAUTION:
Gateway. Connect the strap to an approved ground, such as an unpainted metal surface.
Equipment
Open the box that contains the G450, and ensure that it contains the following components and
accessories:
One G450 chassis. The required media modules that may be installed.
●
An Accessory Kit (see
●
Removing the Power Supply Units
For ease of installation, it is recommended to remove the power supply unit(s) before unpacking the G450.
1. Open the package. Note that the G450 is lying flat. Turn it so that the rear panel is facing up.
2. Remove the power supply unit (PSU). If you ordered two power supplies, remove them both.
a. Loosen the two PSU captive screws, one on each side of the PSU.
b. Grasp the two side handles and pull the PSU up and out.
c. Place the PSU carefully on the table.
Other components
The Avaya Partner Contact Closure adjunct box, if ordered, is packaged separately.
Table
1).
Issue 5 November 2009
7