Ultrasonic Volumetric Protection; Sensor Adjustment; System Reset - Gemini 932 Series Installation And Use Manual

Hide thumbs Also See for 932 Series:

User manual (5 pages)

Installation and use manual (9 pages)

Installation and use manual (9 pages)

Table Of Contents

Table of Contents

nsert the WHITE connector in the "W" marked socket and the RED connector in the "R" marked

socket (see figure below).

Install the ultrasonic sensors on the top part of the windshield internal pillars, away from the air vents

and point them towards the center of the rear window

o check the sensitivity level proceed as follows

With the alarm system disarmed, roll down the front window approx. 20 cm.

Adjust the trimmer at a medium setting.

Close all doors, bonnet and boot and arm the system.

During the arming delay introduce an object in the cabin through the window and move it around;

the status LED will turn off to signal a presence.

If the sensitity lelvel is too high or too low, readjust the trimmer and repeat the above procedure

SENSITIVITY

ADJUSTMENT

This procedure must therefore only be used in case of need, before programming the

To reset the system proceed as follows:

Disconnect the alarm p

hort-circuit the RED and BLACK wires of the 2-pin

Connect the alarm; 4 acoustic signals and 4 flashes of the turn indicators will confirm the alarm is

powered

Remove the previously created short-circuit; the status LED lights up steady.

Turn ignition key "ON";

approx. 3 seconds

Turn ignition key "OFF";

PAGE 16 - INSTALLER MANUAL

15.0 -