Mow Speed
Supervisor (Protected Menu)
Allows the supervisor to set the machine's maximum
mowing speed, in increments of 50%, 75% or 100%,
at which the operator can mow (low range).
Refer to
Setting the Maximum Allowed Mow Speed
(page 24)
for the procedure to set the mow speed.
Operator
Allows the operator to adjust the machine's maximum
mowing speed (low range), within the supervisors
pre-adjusted settings. When in the InfoCenter splash
or main screen, press the middle button (
to adjust the speed.
Note:
When switching between low and high ranges,
the settings transfer based on the previous setting.
The settings reset when the machine is turned off.
Transport Speed
Supervisor (Protected Menu)
Allows the supervisor to set the machines maximum
transport speed, in increments of 50%, 75% or 100%,
at which the operator can transport (high range).
Refer to
Setting the Maximum Allowed Transport
Speed (page 24)
for the procedure to set the transport
speed.
Operator
Allows the operator to adjust the machine's maximum
transport speed (high range), within the supervisors
pre-adjusted settings. When in the InfoCenter splash
or main screen, press the middle button (
to adjust the speed.
Note:
When switching between low and high ranges,
the settings transfer based on the previous setting.
The settings reset when the machine is turned off.
Counterbalance
The counterbalance system maintains hydraulic
back pressure on the deck lift cylinders. This
counterbalance pressure transfers cutting deck weight
to the mower's drive wheels to improve traction. The
counterbalance pressure has been factory set to an
optimal balance of after-cut appearance and traction
capability in most turf conditions. Decreasing the
counterbalance setting can produce a more stable
cutting deck, but can decrease the traction capability.
Increasing the counterbalance setting can increase
the traction capability, but may result in aftercut
appearance issues.
During different times of the mowing season or when
icon)
turf conditions vary, the amount of counterbalance
(upward lift) required on the cutting decks can be
changed to meet the conditions.
Refer to
Setting the Counterbalance (page
procedure to set the counterbalance pressure.
icon)
31
24)for the