Table of Contents
Advertisement
3.
Loosen the jam nut on the stop bolt for the
traction pedal
(Figure
Figure 65
1. Traction pedal
2. Stop bolt w/ jam nut
(forward)
4.
Adjust the stop bolt all the way in (away from
the traction pedal).
5.
Using your hand, push the traction pedal all the
way forward, with light pressure, until it stops
and hold it there. Maintain only light pressure
on the pedal when pushing it to the full forward
position.
6.
With the seat in the raised position, verify that
you are not over loading the linkage by making
sure the transmission does not move when the
pedal is depressed to the stop.
7.
Adjust the stop bolt out (towards the traction
pedal) until there is a gap of 1.5 mm (0.060
inch) between the head of the stop bolt and the
bottom of the traction pedal.
8.
Tighten the jam nut to secure the stop bolt in
place.
9.
The reverse stop bolt may be adjusted if the
maximum reverse speed is not acceptable. For
a faster reverse speed, adjust the stop bolt in.
For a slower reverse speed, adjust the stop bolt
out.
65).
g014893
3. 1.5 mm (0.060 inch)
4. Stop bolt w/ jam nut
(reverse)
Adjusting the Mow Speed
Limiter Lever
The mow speed limiter lever
forward to limit the traction speed while operating.
1.
Disengage the PTO, release the traction pedal
to the neutral position and set the parking brake.
2.
Move the throttle lever to the Slow position,
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3.
Loosen the jam nut on the mow speed limiter
stop bolt
(Figure
1. Mow speed limiter lever
4.
Thread the stop bolt in to increase the mow
speed and out to decrease the mow speed.
5.
Tighten the jam nut to lock the adjustment.
6.
Rotate the mow speed limiter lever down,
operate the machine to verify the adjustment
and readjust the stop bolt as required.
54
(Figure
66) can be flipped
66).
Figure 66
2. Stop bolt w/ jam nut
g014894
Advertisement
Table of Contents
