Controls Maintenance; Adjusting Mow Ground Speed - Toro Reelmaster 3100-D Operator's Manual

Servicing the Engine Belts (continued)
Pump mount tab
Belt-tension spring
Engine pulley
3. Replace the belt.
4. Push down the end of the belt-tension spring, and inward, and align it into the notch in
the pump mount tab.

Controls Maintenance

Adjusting Mow Ground Speed

1. Prepare the machine for maintenance.
2. Loosen the jam nut
.
3. Adjust the speed-stop bolt as follows:
Note:
9.7 km/h (6 mph).
• To decrease the mow speed, rotate the
speed-stop bolt clockwise.
• To increase the mow speed, rotate the
speed-stop bolt counterclockwise.
4. Hold the speed-stop bolt and tighten the jam
nut.
5. Test drive the machine to confirm the maximum mow speed adjustment.
Maintenance: Controls Maintenance
for the speed-stop bolt
The mow speed is set at the factory to
G416950
Drive belt
Hydrostat pulley
G416991
Page 6–28 3466-297 A