Controls System Maintenance; Adjusting Mow Ground Speed; Adjusting The Throttle - Toro Reelmaster 3100-D Operator's Manual

Controls System
Maintenance
Adjusting Mow Ground
Speed
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Loosen the jam nut for the speed stop screw.
3. Adjust the speed stop screw as follow:
Note:
The mow speed is set at the factory to
9.7 km/h (6 mph).
•
To decrease the mow speed, rotate the
speed stop screw
•
To increase the mow speed, rotate the speed
stop screw counterclockwise.
Figure 82
4. Hold the stop screw and tighten the jam nut.
5. Test drive the machine to confirm the maximum
mow speed adjustment.

Adjusting the Throttle

1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood.
3. Position the throttle lever rearward so that it
stops against the control panel slot.
4. Loosen the throttle cable connector on the
injection pump lever arm
44).
(Figure 82) clockwise.
44).
(Figure 83).
1. Injection pump lever arm
5. Hold the injection pump lever arm against the
low idle stop and tighten the cable connector.
6. Loosen the screws securing the throttle control
to the control panel.
7. Push the throttle control lever all the way
forward.
8. Slide the stop plate until it contacts the throttle
lever and tighten the screws securing the throttle
control to the control panel.
9. If the throttle does not stay in position during
operation, torque the locknut, used to set the
friction device on the throttle lever, to 5 to 6 N∙m
(44 to 53 in-lb).
Note:
The maximum force required to operate
g336062
the throttle lever should be 89 N (20 lb).
10. Close and latch the hood.
58
Figure 83
g008918