Cleaning - Siemens 1PH728 Operating Instructions Manual

Lubricating using the regreasing device
Figure 7-1
①
②
1. Clean the grease nipples at the drive end and non-drive end.
2. Press in the type and quantity of grease specified (see lubrication instruction plate).
Note
The shaft should rotate so that the new grease can be distributed throughout the bearing.
The bearing temperature rises sharply at first, then drops to the normal value again when the
excess grease is displaced out of the bearing.
[ID: 360.01]
7.1.5

Cleaning

Cleaning the greasing channels and used grease chambers
The used grease collects outside each bearing in the used grease chamber of the outer
bearing cap. Remove the used grease when you replace a bearing.
Siemens AG A5E00177602A
Operating Instructions V 2.0 1PH728
D-end and N-end end shields with grease nipples
Button head lubricating nipple to DIN 3404, size M10x1, drive end (DE)
Button head lubricating nipple to DIN 3404, size M10x1, non-drive end (NDE)
Maintenance
7.1 Maintenance
7-5