Connecting The Temperature Sensor - Siemens 1PH728 Operating Instructions Manual

Installation / Assembly

3.10 Connecting the temperature sensor

Notice
Changing the cable outlet direction by any improper means will cause damage to the
connecting cables.
The permissible rotation range must not be exceeded. A maximum of ten changes to the
rotation angle of the sensor module are permissible within the rotation range.
[ID 964]
3.10 Connecting the temperature sensor
Connection
Connect the wires of the temperature sensor to the speed sensor connector with the aid of
connecting leads (see section entitled "Connecting the speed sensor").
Note
The plug-in connection may differ from the standard layout in the case of special orders.
In the version "without sensor", an armored conduit union is located here (PG 13.5). It is
screwed into the thread for the sensor connector. Information about connection is provided in
the auxiliary terminals diagram K789281.
The motors are fitted with a back-up temperature sensor, which is likewise connected to the
auxiliary terminals and, if necessary, can be reconnected to the plug connector of the speed
sensor (see auxiliary terminals diagram).
[ID: 341.01]
3-14
Siemens AG A5E00177602A
Operating Instructions V 2.0 1PH728