Figure 7-5
①
②
③
[ID: 371.01]
See also
• Lubrication (Page 7-3)
7.3.3
Re-assembly
Re-assembly instructions
If possible, assemble the machine on a surface plate. This ensures that the feet surfaces are
all on the same level.
Notice
When mounting the end shield, make sure that the windings that project from the stator
housing do not become damaged.
Notice
Take great care and pay attention to cleanliness when fitting and assembling the bearings.
Siemens AG A5E00177602A
Operating Instructions V 2.0 1PH728
Disassembling the speed sensor: forcing off, 2nd option
Release the retaining screw.
Press the screw M10 onto the original screw. This causes it to fall out.
Remove the sensor.
Maintenance
7.3 Repair
7-13