Viessmann Vitocal 300-G Series Installation And Service Instructions Manual page 77

Electrical equipment
Pos. Part
0001 Programming unit, Vitotronic 200 heat pump control unit
0002 Controller and sensor PCB with cover (CU401)
0003 Base support, controller and sensor PCB (CU401)
0004 Main PCB with cover (MB761)
0005 Base support, main PCB (MB761)
0006 Expansion PCB with cover (SA135)
0007 Coding card for 1-stage heat pump
Coding card for 2-stage heat pump
See part no. printed on the coding card "7.....".
0008 EEV PCB (IU210-A10)
0009 Full wave soft starter
0012 Casing, programming unit
0020 Cable channel
0021 Body-bound rivet
0022 Cross connect PCB with support (SA 112)
0023 Cable set, cross connect PCB (SA 112)
0024 Switching module, compressor 400 V~, 17 to 23 A
0025 Contactor, 3-pole 230 V~ (K3-40A00)
0026 Contactor, 3-pole 230 V~ (K2-30A10)
0027 Thermal relay (17 to 23 A)
0028 Three-phase monitor
0030 Mains terminals
0036 Fuses 6.3 A (slow) (5 pce)
0037 Outside temperature sensor
0038 Mating plug for controller and sensor PCB (set)
0039 Mating plug for main PCB (set)
0040 Mating plug for expansion PCB (set)
0041 Ribbon cable 24 x 0.09
0042 4-pole connecting cable, length 85 mm
0043 Connecting cable, compressor
0049 Cable set, EEV sensors
0050 Cable harness, low voltage (X5)
0054 Cable harness 230 V~
0055 Transformer
0056 Cable harness, EEV module
0057 Cable harness, power supply EEV
0071 Power cable
0072 Relay, start delay
(cont.)
Parts list type BW 301.A
77