Viessmann Vitocal 300-G Series Installation And Service Instructions Manual page 101

Control parameter report
DHW
Parameter
Set DHW temperature
Min. DHW temperature
Max. DHW temperature
Hysteresis DHW temperature heat pump
Hysteresis DHW temperature booster heat-
er
Start optimisation for DHW heating
Stop optimisation for DHW heating
Set DHW temperature 2
Temperature rise per hour for DHW heating
Temperature sensor at bottom of DHW cyl-
inder
Max. runtime DHW heating in heating mode 6011
Max. interruption of DHW heating for central
heating
Enable booster heaters for DHW heating
Enable electric heaters for DHW heating
Priority DHW heating with combi cylinder
Start attempts for DHW after high pressure
shutdown
Shutdown hysteresis inst. heating water
heater
Cylinder primary pump enable
Operating mode cylinder primary pump
Enable elec. heating/ext. HS for reheating
only
Solar
Parameter
"Type solar control unit"
Parameters for solar control module, type
SM1
(cont.)
Code Delivered condition Commission-
6000 500 (
6005 100 (
6006 600 (
6007 50 (
6008 100 (
6009 0
600A 0
600C 600 (
600D 30 K/h
600E 0
240 min
6012 90 min
6014 0
6015 0
6016 0
6017 1
601E 0 (
601F 0
6020 0
6040 0
Code Delivered condition Commission-
7A00 0
C0xx These parameters will only be displayed if the solar
control module, type SM1, is connected to the heat
pump and "Type solar control unit" is set to "3".
For a description of the parameters, see installation
and service instructions for "solar control module, type
SM1".
Commissioning/service reports
ing
≙
50 °C)
≙
10 °C)
≙
60 °C)
≙
5 K)
≙
10 K)
≙
60 °C)
≙
0 K)
ing
Maintenance/
service
Maintenance/
Service
101