Lubrication; Valves; Fuses - Stiga TITAN Series Instructions For Use Manual

6. If the air filter must be replaced, pull this out as
well.
7. Reassemble all parts in the reverse order.
8. Reset the filter indicator if it has tripped. See
"3.5.7".

6.14 Lubrication

All lubrication points according to the table below
must be lubricated after every 50 operating hours
as well as after each clean.
Use a grease gun, filled with universal grease.
Pump until grease protrudes. The lubrication
points are shown in fig. 28-30.
Note the belts when lubricating. Belts
must not come into contact with oil or
grease.
Object Lubrication nipples /
action
Tension arm, 1 lubrication nipple.
pump belt
Lifting fork, 1 lubrication nipple
turning
Lifting fork, 2 lubrication nipples
up-down
Lifting cylin- 2 lubrication nipples
der
Control cylin- 2 lubrication nipples
der
Pivot point 3 lubrication nipples
Tension arm, 1 lubrication nipple.
Be careful with the
auxiliaries
belts. Belts must not
belt
come into contact with
(Only 20B
grease.
and 26B)
Tension arm, 1 lubrication nipple.
Be careful with the
rear imple-
belts. Belts must not
ment belt
come into contact with
(Only 20B
grease.
and 26B)
Throttle cable Lubricate the cable ends
using an oil can at the
same time as activating
the respective control.
Preferably carried out by
two people.

6.15 Valves

Valve adjustment and grinding should be carried
out by authorised workshops.
ENGLISH

6.16 Fuses

If any of the following faults occur, replace the rel-
evant fuse. The fuses are under the cover in fig. 25.
Remove the cover by removing the 5 screws.
Check and replace blown fuses. If the fault per-
sists, contact an authorised workshop.
Fault
Indicator lamps, buzzer,
hold valve transport posi-
tion
Cutting height, sand
spreader, rear rake, head-
light
Cruise control, alternator
Electric socket on panel
Shut off pull
PTO, warning lamp park-
Figure
ing, safety relay
Spare
30:A
Main fuse
30:B
30:G, H
30:C, E
30:D, F
30:J
28
30:K
29
GGP reserves the right to make alterations to the
product wit
GB
Fuse
Location Rating
25:A 10 A
25:B 20 A
25:C 10 A
25:D 10 A
25:E 30 A
25:F 10 A
25:G
25:H 40 A
87