Air Filter Indicator; Water Separator; Fuel Filter; Safety Checks - Stiga TITAN Series Instructions For Use Manual

GB
5.4.1 Topping up with coolant
The coolant must meet the following require-
ments:
• Always use a mixture of refrigerant and water.
Never use just water.
• Mix the water and refrigerant according to the
refrigerant supplier's instructions.
• Never mix different refrigerants.
• Use soft water (no calcium content), distilled or
demineralised water.
The engine must be cold when filling.
If the radiator cap is opened when the
engine is hot there is a risk of serious
burn injuries from hot water that may
spray out.
Top up as follows:
1. Remove the front engine cover.
2. Check that all the plugs in the cooling system
are installed and sealed.
. Check that all the taps in the cooling system are
closed and sealed.
4. Check that all the hoses in the cooling system
are intact and sealed.
5. Unscrew the radiator cap (13:C).
6. Slowly fill the radiator with coolant. Air bub-
bles must not form when filling. Fill up to the
filler hole.
7. Reinstall the radiator cap.
8. Open the cap on the expansion tank (12:K) and
top up the mixture to the lower mark which is
the level when the engine is cold.
9. Close the cap for the expansion tank.
10.Run the engine to operating temperature and
check the level in the expansion tank. The level
should now be at the upper mark (12:T), which
is the level for when the engine is hot.
11.If the level is not up to the upper mark, allow the
engine to cool and then top up with coolant in
the expansion tank.

5.5 Air filter indicator

Check to make sure that the air filter indicator (21,
22:I) has not been tripped.
Check, see "3.5.7".
Replace the air filter, see "6.13".

5.6 Water separator

Check that the water separator's float (15:E) is at
the bottom. See "5.6".
Check that the water separator's tap is open. See
fig. 15.

5.7 Fuel filter

Check that the fuel filter's tap is open. See fig. 14.
82
ENGLISH

5.8 Safety checks

Check that the results of the safety checks below
are met when testing the machine.
The safety checks must always be car-
ried out before use.
If any of the results below are not met,
the machine must not be used! Take the
machine to a service workshop for
repair.
5.8.1 General safety checks
Object
Fuel lines and con-
nections.
Power cables.
Exhaust system.
Hydraulic hoses.
Drive the machine
forwards/back-
wards and release
the drive/service
brake pedal.
Test driving.
5.8.2 Electric safety check
The safety system's function must
always be checked before use.
Status
The clutch-brake
pedal not
depressed.
PTO not activated.
The clutch-brake
pedal not
depressed.
PTO activated.
Engine running.
PTO activated.
Cruise control acti-
vated.
Cruise control acti-
vated.
Control for imple-
ment lifter not in
floating position.
Result
No leak.
All insulation intact.
No mechanical damage.
No leakage in the connections.
All screws tightened.
No leakage. No damage.
The machine should stop.
No unusual vibrations.
No unusual noise.
Action Result
Attempt to start. The engine
should not
start.
Attempt to start. The engine
should not
start.
The operator PTO should
leaves the seat. disengage.
The operator Cruise con-
leaves the seat. trol should
disengage.
Clutch-brake pedal Cruise con-
depressed. trol should
disengage.
Attempt to engage PTO should
PTO. not be able
to be
engaged.