Step 4: Replacing The Wipers And Felt Wipers - Roland ECO-SOL MAX3 Instruction Manual

Switching the Ink

STEP 4: Replacing the Wipers and Felt Wipers

If a warning beep sounds during operation
Attach the left and right covers, close the front cover, and then press
the operations with the procedures in this manual. Refer to the user's manual of the model that you are using
and perform the operations according to the details listed under P. 20 "When Operations Are Interrupted".
CAUTION
1.
Replace the wipers.


Replace the first wiper.

Press

10
ECO-SOL MAX 3 Ink Switching Method
Be sure to perform operations as specified by the instructions, and never touch any
area not specified in the instructions.
Failure to observe these instructions may cause the machine to move suddenly, resulting
in injury.
Open the right cover.
Preparations are complete when this screen appears.
Removing an old wiper
Tweezers (included)
Hook
Disconnect the hooks.
Using the tweezers to press on the hook in the hole on
the wiper makes it easier to remove the wiper.
Attaching a new wiper
Place the inclined end on the back side.
If the wiper is installed with the incorrect
orientation, appropriate cleaning will not
be possible.
.
Close the right cover.
. After this, you cannot continue
If the area is dark and difficult
Pull up and
to see, use a flashlight or a
out.
similar device to illuminate
the area.
Attach the part to the hooks.
Be sure to attach the part to the
hooks. Failure to do so may result
in dot drop-out or other problems.
Hook