Change: Cleaning Locations During Manual Cleaning; Daily Precautions - Roland ECO-SOL MAX3 Instruction Manual

Important: Changes and Precautions after Switching the Ink

Change: Cleaning Locations During Manual Cleaning

Clean the locations indicated in the following figure when performing manual cleaning after switching to MAX 3 ink.
Exercise special care in wiping off any accumulated ink. You can make the accumulated ink easier to clean off by applying
cleaning liquid to the cleaning locations, and then wiping these locations off with the cleaning stick. Only moisten the part
indicated with diagonal lines in location
 Also carefully clean the sides of the print heads.
 During this work, be careful not to touch the print head
surface (nozzle surface) directly with the cleaning stick.

Daily Precautions

Do not leave the front, left, and right covers open.
Only open the front cover when necessary, such as when setting media. In all other situations, be sure to close the front cover.
Be sure to close the left and right covers after performing maintenance.
This machine periodically performs automatic maintenance, but this will not be performed if the front cover is open. If the
machine is left with the front cover open, the print heads may malfunction.
If the message "TIME FOR MAINTENANCE" is displayed, be sure to perform manual cleaning.
If the message "TIME FOR MAINTENANCE" is displayed on the printer screen, be sure to perform manual cleaning.
 P. 17 "Change: When to Perform Manual Cleaning"
Regarding ink cartridge storage
Store ink cartridges with their seals intact and in a well-ventilated location at a temperature of -5°C to 40°C.
However, do not store ink cartridges for a prolonged period of time in low or high temperature environments.
18
ECO-SOL MAX 3 Ink Switching Method
with cleaning liquid on the cleaning stick.
Area to clean
Area to moisten
Felt
wiper
There are two wipers and two felt wipers.
Wiper