General Maintenance
5.2
Periodic Maintenance Schedule
The table below lists basic machine maintenance. Tasks designated with check
marks
points require special training and equipment.
Lubricate trowel arms.
Check external hardware.
Pressure wash all surfaces until free of
concrete.
Check oil level in gearboxes.
Lubricate gearbox input shaft fitting.
Lubricate drive and pitch controls.
Check drive belt for wear.
Lubricate steering cylinder pivots.
Replace oil in gearboxes.
may be performed by the operator. Tasks designated with square bullet
Every 20
Daily
hours
50
CRT48
Every
Every 50
300
hours
hours
wc_tx004194gb_FM10.fm