Break-In Period; Before Starting - Husqvarna CRT 48-35L Operator's Manual

Operation
4.8

Break-In Period

Overview This machine requires a break-in period for the engine and the gearbox.
Gearbox To break in the gearboxes, run the engine at 50% of full throttle for the first 2–4
break-in
hours. This will prevent premature wear and extend gear life.
period
NOTICE: Running the engine at full throttle during the break-in period could result
in premature gear failure.
Kohler engine Follow the recommendations below while operating the machine during the break-
break-in
in period.
period
■ The Kohler engine has a 50-hour break-in period.
■ During the first 50 hours, do not exceed 70% of maximum rated power.
■ Change the engine oil and oil filter after the first 50 hours of operation.
■ Allow the engine to warm up completely before operating the machine in cold
weather.
Vanguard Follow the recommendations below while operating the machine during the break-
engine break-
in period.
in period
■ Do not operate at full load during the first 5–10 hours of operation.
■ Change the oil after the first 5–10 hours of operation.
■ Allow the machine to warm up completely before operating the machine in cold
weather.
Kubota engine Follow the recommendations below while operating the machine during the break-
break-in
in period.
period
■ Change the oil and oil filter after the first 50 hours of operation.
■ Allow the machine to warm up completely before operating the machine in cold
weather.
4.9

Before Starting

Requirement Operator must be familiar with the location and function of all controls.
Checklist Check the following items before starting the trowel:
 fuel level—add fuel as needed
 oil level in the engine—add oil as needed
 water level—add water as needed
 air filter—element is clean and undamaged
 trowel arms and blades—functional and undamaged
40
CRT48
wc_tx004193gb_FM10.fm