CRT48
5.5
Lubricate the Trowel Arms
Requirements ■ Machine stopped
■ Grease (Unirex N2) or equivalent
Procedure
Perform the procedure below to grease the trowel arms.
1. Set the trowel on a flat, level surface.
2. Disconnect the battery.
3. For access, pitch the blades to the maximum angle.
4. Apply grease to each zerk (a) on the spider assembly.
5. Apply grease to the lifting ring (b) on each side of the machine.
Note: Graphic is representative only. Your machine may vary.
Result
The trowel arms have now been greased.
wc_tx004194gb_FM10.fm
General Maintenance
a
55
wc_gr011908
b
wc_gr011909