Machine Components Descriptions - Husqvarna CRT 48-35L Operator's Manual

CRT48
4.4

Machine Components Descriptions

Ref.
a
b
c
d
e
f
g
h
j
k
Operator The Ride-On Trowel features a seat with an integrated "operator presence" system
presence
which works in conjunction with a throttle-mounted switch. This system allows the
system
engine to remain running (idling) with no operator seated in the seat, as long as the
throttle is not depressed.
The purpose of the "operator presence" system is to reduce the throttle to idle if the
operator leaves the seat. The "operator presence" system meets requirement
published by organizations such as OSHA, ANSI, and ISO.
Learning to To familiarize a new operator with the Ride-On Trowel, the following steps should
operate the
be taken:
trowel
1. With the operator in the seat, show him or her the functions of the steering
levers (c) and how to start the machine.
2. Have the operator practice steering the trowel. A hard concrete slab slightly
wetted with water is an ideal surface on which to practice.
3. Pitch the blades up approximately 6.35 mm (¼") on the leading edge. Start by
making the machine hover in one spot, and then practice moving the machine in
a straight line and making 180° turns. The best control is achieved at full rpm.
wc_tx004193gb_FM10.fm
Description
Right pitch control
Fuel tank
Steering levers
Operator's seat with "operator
presence" switch
Left pitch control
Rear work light (one each side)
Water tank
Front work light (one each side)
Foot pedal (throttle control)
Engine choke control (if equipped)
Ref. Description
m Work light switch
n Glow plug indicator light
(if equipped)
o Engine keyswitch
p Hour meter
q Water spray control
r Oil pressure indicator light
s Alternator charging indicator light
(if equipped)
t Coolant temperature indicator light
(if equipped)
u Check engine indicator light
(if equipped)
— —
37
Operation