General Maintenance
5.6
Mounting Float Pans
Background
Certain applications may require the use of float pans. Optional float pans are
available from your Wacker Neuson dealer. The blade arms on the machine are
designed to accommodate either a standard 48" lip-style float pan or an optional
smaller 46" pan. An alternative set of blade mounting holes is provided for mount-
ing a 46" pan.
Requirements ■ Machine stopped
■ Lifting devices with enough weight-bearing capacity to lift the machine
■ Properly rated jack stands
Mounting a
Perform the procedure below to mount a 48" float pan.
48" float pan
1. Stop the engine.
2. Using an appropriate hoist or crane, raise the machine off the ground so that the
blades will not touch the ground.
3. Set the machine on jack stands (a) as shown below.
Note: Graphic is representative only. Your machine may vary.
4. Position each float pan (b) against the blades, and turn the pans either left or
right to engage clip angles (c) as shown.
Note: Right-hand trowel blades turn counter-clockwise; left-hand trowel blades turn
clockwise.
c
This procedure continues on the next page.
a
b
wc_gr011865
56
CRT48
wc_gr011869
wc_tx004194gb_FM10.fm