Advertisement
D. Install the Plumbing
CAUTION: Risk of property damage. Make
sure a watertight seal exists on all bath drain
connections.
NOTE: Provide access to all plumbing connections to
simplify future maintenance.
·
Connect the trap to the drain according to the faucet
manufacturers instructions.
·
Install the faucet valving according to the faucet
,
manufacturer
s
instructions. Do not install the faucet
trim at this time.
·
Open the hot and cold water supplies and check all
connections for leaks.
·
Run water into the bath and check the drain
connections for leaks.
·
Fill the bath to the overflow and check for leaks.
D.
·
·
·
·
·
COMPLETE THE INSTALLATION
COMPLETE THE INSTALLATION
For Drop-In Installations
·
Cover the framing with water-resistant wall material.
Seal the joints between the bath rim edges and the
water-resistant wall material with silicone sealant.
·
Tape and mud the water-resistant wall material.
·
Install the finished wall. Seal the joints between the
bath rim and the finished wall with silicone sealant.
CLEAN-UP
When cleaning up after installation, do not use abrasive
cleansers as they may scratch and dull the surface.
Use warm water and liquid, non-abrasive detergent to
clean the surface.
CAUTION: Do not allow cleaners containing
petroleum distillates to remain in contact with the
surface for long periods of time.
Remove stubborn stains, paint, or tar with turpentine or
paint thinner.
Remove plaster by scraping with a wood edge. Do not
use metal scrapers, wire brushes, or other metal tools.
You can use a powder-type detergent on a damp cloth
to provide mild abrasive action to any residual plaster.
1023725-T01-A
Finished Deck Material
Bath
·
·
·
11
Apply Silicone Sealant To The Edges
Of The Water-resistant Deck Material
And The Finished Deck
Water-resistant Deck Material
Framing
Advertisement
