S5130-54C-Hi - H3C S5130-HI Series Installation Manual

S5130-54C-HI

Figure 72 S5130-54C-HI front panel
(1) 10/100/1000BASE-T autosensing Ethernet port
(3) Management Ethernet port
(5) Mini USB console port
(7) USB port
(9) SFP+ port
(11) Expansion card status LED (SLOT)
(13) Power module 1 status LED (PWR1)
(15) Management Ethernet port LED
Figure 73 S5130-54C-HI rear panel
(1) Grounding screw
(3) Fan tray slot 1
(5) Power module slot 1
The S5130-54C-HI switch comes with power module slot 1 empty and power module slot 2 installed
with a filler panel. You can install one or two power modules for the switch as required. In this figure,
two PSR150-A1 AC power modules are installed in the power module slots. For more information
about installing and removing a power module, see
The S5130-54C-HI switch comes with the two fan tray slots empty. You must install two fan trays of
the same model for the switch. In this figure, two LSPM1FANSA fan trays are installed in the fan tray
slots. For more information about installing and removing a fan tray, see
tray."
The S5130-54C-HI switch comes with a filler panel in the expansion card slot. You can select an
expansion card for the switch as required. In this figure, an LSWM2SP2PM interface card is installed
in the expansion card slot. For more information about installing and removing an expansion card,
see "Installing/removing an expansion
(2) 10/100/1000BASE-T autosensing Ethernet port
LED
(4) Console port
(6) Port LED mode switching button (MODE)
(8) System status LED (SYS)
(10) Port mode LED
(12) Power module 2 status LED (PWR2)
(14) SFP+ port LED
(2) Expansion card slot
(4) Fan tray slot 2
(6) Power module slot 2
"Installing/removing a power
card."
57
module."
"Installing/removing a fan