Cleaning Stainless Steel Surfaces; Cleaning Coils; Cleaning Under Merchandisers; Removing Scratches From Bumper - Hussmann RL2W Installation & Operation Manual

P/N 3053328_C
CLEANING STAINLESS STEEL
SURFACES
Use non-abrasive cleaning materials, and always polish
with grain of the steel. Use warm water or add a mild
detergent to the water and apply with a cloth. Always
wipe rails dry after wetting.
Use alkaline chlorinated or non-chlorine containing
cleaners such as window cleaners and mild detergents.
Do not use cleaners containing salts as this may cause
pitting and rusting of the stainless steel finish. Do not
use bleach.
Clean frequently to avoid build-up of hard, stubborn
stains. A stainless steel cleaning solution may be used
periodically to minimize scratching and remove stains.
Rinse and wipe dry immediately after cleaning. Never
use hydrochloric acid (muriatic acid) on stainless steel.

CLEANING COILS

NEVER USE SHARP OBJECTS AROUND COILS.
Use a soft brush or vacuum brush to clean
debris from coils.
Do not puncture coils!
Do not bend fins. Contact an authorized service
technician if a coil is punctured, cracked, or otherwise
damaged.
Do NOT use chlorine or ammonia-based cleaners to
clean aluminum coils.
ICE in or on the coil indicates the refrigeration and
defrost cycle is not operating properly. Contact an
authorized service technician to determine the cause
of icing, and to make adjustments as necessary. To
maintain product integrity, move all product to a
cooler until the unit has returned to normal operating
temperatures.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Do NOT allow cleaning agent or
cloth to contact food product.

CLEANING UNDER MERCHANDISERS

Remove splashguards not sealed to floor. Use a
vacuum with a long wand attachment to remove
accumulated dust and debris from under the
merchandiser.
REMOVING SCRATCHES FROM
BUMPER
Most scratches and dings can be removed using the
following procedure.
1. Use steel wool to smooth out the surface area of
the bumper or top rail.
2. Clean area.
3. Apply vinyl or car wax and polish surface for a
smooth glossy finish.
5-3
Reach-In