Cleaning Stainless Steel Surfaces; Cleaning Under Step Pan; Cleaning Thermometer; Cleaning Coils - Hussmann microSC SHM-A Series Installation & Operation Manual

4-2 MAINTENANCE
Soap and water may be used if all water is
removed from the honeycomb cells before
replacing. Be careful not to damage the honey-
comb.
1. Using a flat object such as a screw driver,
compress the honeycomb and remove it
from its retainer.
2. Clean and dry the honeycomb.
3. After cleaning, replace in reverse order.
Damaged honeycomb must be replaced.

CLEANING STAINLESS STEEL SURFACES

Use non-abrasive cleaning materials, and
always polish with grain of the steel. Use warm
water or add a mild detergent to the water and
apply with a cloth. Always wipe rails dry after
wetting.
Use alkaline chlorinated or non-chlorine
containing cleaners such as window cleaners
and mild detergents. Do not use cleaners
containing salts as this may cause pitting and
rusting of the stainless steel finish. Do not use
bleach.

CLEANING UNDER STEP PAN

Remove all product from the merchandiser and
place in cooler. Always disconnect electrical
power before cleaning.
1. Place a small screw driver between the
front grille and step pan. Gently lift the
step pan's front lip up. Grasp the step pan
with both hands to remove. Always wear
gloves when removing step pan.
P/N 3104942_B
2. Use non-abrasive cleaning materials and a
mild detergent to clean the step pan.
Use only enough water necessary to clean
surface. Water must not drip down the case!
Never use ammonia based cleansers, abrasive
3. Wipe down the insides of the merchandiser
with a mild detergent, and replace step pan.

CLEANING THERMOMETER

Remove the two screws holding the thermometer
to its mounting bracket. Remove the sensing
element from its clip. Clean the element with
water and mild detergent solution. Ensure the
sensing element is wiped clean of any residue to
ensure proper temperature readings.

CLEANING COILS

Condenser coils should be cleaned at least
once per month. Additional cleaning may be
needed depending on the operational environ-
ment. A dirty condenser blocks normal airflow
through the coils.
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
DO NOT FLOOD!
cleansers, or scouring pads.
Step Pan