Hussmann RL2W Installation & Operation Manual page 13

P/N 3053328_C
Shipping
Block
Figure 2. Remove Shipping Block
(One From Each Side of Island Models)
RMN
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
D
o not use shipping bolts to join cases
Shipping Brace
Figure 3. Remove Shipping Braces
2
Locate and remove the shipping block in the
center of the heat exchanger in the interior
bottom of each case, see Figure 2.
Snap a chalk line on the floor to use as a guide
for positioning the front of the cases in the
line-up. The front base frame should be on the
chalk line.
3
Once cases are close to final placement, remove
the shipping braces from the ends to be joined,
see Figure 3. Discard bolts and flat washers
used to hold shipping braces. Bolts are too
long to be used for joining.
RLNI / RLNI
1-7
!
Reach-In