Hussmann RL2W Installation & Operation Manual page 9

P/N 3053328_C
NOTE: B
egin lineup leveling from the highest point
.
of the store floor
Place shims under the rail and make sure that they
are positioned at a base component (crossbar). This
transfers the weight directly from the loaded case
through to the floor.
Placing shims at other locations will cause uneven
distribution of weight leading to piping leaks, as well
as sagging or wracked doors.
Bottom front supports must be shimmed if not in full
contact with the floor.
It is the installing contractor's
responsibility to consult local agencies
for local code requirements.
4-Door Shown
Electrical Wireway
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Back
Back
Skid/External Base
Front
Front
Approximately
Centered
Rear of Reach-in
Base Component
Shim Here
Shim
Here
Bottom Front
Support
1-3
Base Component
Shim Here
Shim Here
Reach-In